EDM Broken Tap Removers: Why the Workpiece Thread Survives

2026-10-29
EDM Broken Tap Removers: Why the Workpiece Thread Survives - Nenghua Power
Photo: Jinan Nenghua real products

A tap breaking off inside a hole is a common workshop accident. Manual extraction, drilling or welding a handle gives inconsistent results and tends to damage the finished thread. An EDM broken tap remover erodes the tap by electrical discharge and removes it without harming the workpiece thread. The principle is the same as ordinary EDM, but the supply and process are specialized.

Basic principle

A conductive electrode, usually brass or a copper tube, is aimed at the broken tap. A tiny gap is maintained between electrode and tap while a pulse voltage is applied. The instantaneous heat of each discharge melts and vaporizes tap material locally; as material is removed, the electrode feeds forward and gradually hollows out the tap.

Why the thread survives

It comes down to electrode position relative to the workpiece and the selectivity of erosion:

Effect of pulse parameters

ParameterImpact
Pulse widthSets removal per pulse; narrow widths protect the surroundings
Peak currentSets removal speed; too high causes roughness and damage
Pulse intervalDeionization and flushing; too short causes arcing
Electrode jump or vibrationFlushes the deep hole; essential for stable machining

Dielectric and flushing

The tap sits at the bottom of a deep hole, so erosion products are hard to remove and discharges become unstable. These machines therefore emphasize flushing: dielectric is injected through the electrode bore or from the side to carry products away. The choice of dielectric and its filtration matter as much as the electrical settings.

Scope and cautions

It works for broken taps and drills in conductive workpieces. It does not work on non-conductive materials, and taps that are heavily deformed or jammed extremely tight are markedly harder. The operator must control feed speed and jump rhythm to avoid shorting the electrode to the workpiece. See high-frequency pulse supplies and pulse power supplies; more solutions are in the pulse power category.

Related Articles

All News

Frequently Asked Questions

Basic principle?
A conductive electrode, usually brass or a copper tube, is aimed at the broken tap. A tiny gap is maintained between electrode and tap while a pulse voltage is applied. The instantaneous heat of each
Why the thread survives?
It comes down to electrode position relative to the workpiece and the selectivity of erosion: The electrode is guided and constrained to the central area of the tap, kept away from the workpiece threa
Effect of pulse parameters?
ParameterImpact Pulse widthSets removal per pulse; narrow widths protect the surroundings Peak currentSets removal speed; too high causes roughness and damage Pulse intervalDeionization and flushing;
Dielectric and flushing?
The tap sits at the bottom of a deep hole, so erosion products are hard to remove and discharges become unstable. These machines therefore emphasize flushing: dielectric is injected through the electr
Scope and cautions?
It works for broken taps and drills in conductive workpieces. It does not work on non-conductive materials, and taps that are heavily deformed or jammed extremely tight are markedly harder. The operat