
On bipolar pulse supply datasheets the "negative pulse" is often treated as a selling point. But more reverse is not automatically better — it has a specific physical function, and misusing it lowers throughput. Understanding what it does is the only way to set parameters correctly.
During the forward pulse, current density is naturally highest at protruding points, so they plate fastest and the surface becomes rougher. With a reverse pulse, those same peaks see the highest current density and dissolve fastest. High spots dissolve more and low spots less, so the surface levels out gradually. This is the core mechanism behind uniformity gains in periodic-reversal plating.
Forward deposition depletes metal ions at the electrode surface, creating a gradient. The reverse phase gives ions time to diffuse back and briefly refreshes the interface, so every forward pulse starts from a consistent interfacial state.
In MAO and anodizing, the reverse field suppresses arc growth and drives ions deeper into the film, making it denser and more uniform. In plating, reverse pulses also refine grain and reduce internal stress.
The reverse phase dissolves some of the metal just deposited, so deposition efficiency necessarily drops. The stronger and longer the reverse, the greater the loss. The rule is just enough: aim for the minimum reverse that achieves leveling and densification, rather than maximizing it.
| Parameter | Recommendation |
|---|---|
| Forward/reverse time ratio | Forward far longer than reverse; a large ratio is typical |
| Reverse amplitude | Usually comparable to or slightly below forward; tune for leveling |
| Frequency | Slow enough for the reverse phase to actually act |
| Dead time | Insert a very short blanking interval at transitions to prevent shoot-through |
Confirm whether positive and negative amplitudes are independently adjustable, the frequency and duty range, dead-time control at transitions, and whether periodic reversal with blanking intervals is supported. See bipolar pulse supplies and dual pulse supplies; more solutions are in the pulse power category.
Insulation condition in power equipment, cables and motors …
2026-10-29Low-temperature (non-equilibrium) plasma is widely used for…
2026-10-29Electrochemical machining (ECM) and electrochemical grindin…
2026-10-29Formation, capacity grading and performance testing on a li…
2026-10-29Conventional food sterilization relies on heat, and pays fo…
2026-10-29Refractory wastewater from dyeing, pharmaceuticals and chem…