Why Hard Anodizing Benefits from Combined Constant-Current and Pulse Modes: Balancing Film Breakdown and Temperature Rise

2026-10-24
Why Hard Anodizing Benefits from Combined Constant-Current and Pulse Modes: Balancing Film Breakdown and Temperature Rise - Nenghua Power
Photo: Jinan Nenghua real products

Hard anodizing reaches 40–80 μm films through high current density, cold electrolyte and long dwell times. But as the film thickens, resistance rises, voltage climbs under constant current, and the risk of local breakdown and burning grows. That is why many hard-anodizing lines now run pulse supplies — or at minimum a dual mode: constant current to establish the film, pulse to sustain it.

Why the constant-current phase matters

The first 5–15 minutes establish a dense barrier layer, and constant current is the steadiest way to do it: density fixed at 2–3 A/dm², voltage rising naturally. Constant current delivers consistent charge per unit area and therefore the best thickness uniformity. Starting on pulse immediately often produces a porous layer and colour variation, because the barrier grows discontinuously.

Why the pulse phase matters

Beyond 20–30 μm the question shifts from "will it grow" to "will it grow well":

The pulse phase exists to give heat somewhere to go. A 60%–80% duty cycle at 100–500 Hz is typical: enough average current to keep growing, enough off-time to let the interface cool.

When to switch modes

Three signals indicate it is time to move from constant current to pulse:

Do not switch abruptly: reduce average current by 10%–20%, then raise duty cycle gradually while watching voltage stability.

Practical parameter window (6061 / 7075)

Typical faults

Grey film, low hardness — usually high bath temperature or low average density; check cooling first, then whether the duty cycle is suppressing average current too far. Localised black burn marks — poor rack contact concentrating current at that point; clean contact faces or add an auxiliary cathode. More than 10 μm difference top to bottom — agitation or cathode placement; pulse shaping cannot fix a flow problem.

What to require from the supply

Three capabilities: switchable constant-current and pulse modes without current steps at the transition; sufficient voltage ceiling, since hard anodizing commonly reaches 80–120 V and some alloys more; and A·h charge metering with automatic stop at target. The first two decide whether a conforming film is possible at all; the third decides batch consistency.

Suitable equipment includes our anodizing pulse power supplies with dual mode and A·h metering, and aluminium anodizing rectifiers for high-current constant-current duty; long, thick-film processes benefit from water-cooled, derated models.

Related Articles

All News

Frequently Asked Questions

Why the constant-current phase matters?
The first 5–15 minutes establish a dense barrier layer, and constant current is the steadiest way to do it: density fixed at 2–3 A/dm², voltage rising naturally. Constant current delivers consistent c
Why the pulse phase matters?
Beyond 20–30 μm the question shifts from "will it grow" to "will it grow well": The thermal window narrows. The film conducts heat poorly, so Joule heat concentrates inside it; a hot interface acceler
When to switch modes?
Three signals indicate it is time to move from constant current to pulse: Voltage slope flattens — the film has become a significant resistance, usually around 20–30 μm. Bath temperature approaches it
Practical parameter window (6061 / 7075)?
Current density: 2.0–3.0 A/dm² constant current; 1.5–2.5 A/dm² average in pulse mode Duty cycle: 60%–80%, dropping to 50% above 40 μm Frequency: 100–500 Hz — higher for thin parts, lower for thick sec
Typical faults?
Grey film, low hardness — usually high bath temperature or low average density; check cooling first, then whether the duty cycle is suppressing average current too far. Localised black burn marks — po