Why Pulse Power Supplies Win in Dry Etching

2026-10-28
Why Pulse Power Supplies Win in Dry Etching - Nenghua Power
Photo: Jinan Nenghua real products

In semiconductor dry etching, etch uniformity often runs into the "micro-loading effect": on the same wafer, small high-aspect-ratio holes and trenches etch noticeably slower than larger features. Continuous-wave (CW) supplies improve this only marginally, while pulse (PW) supplies tackle it directly. Here is why pulse fits advanced etching.

CW vs PW

Under CW the supply delivers power continuously; the plasma never rests. Pulse mode chops the output into on-off cycles — full power for part of the period, off for the rest. That intermittent energy input creates a valuable "breathing window" for the process.

Three practical benefits

Beating micro-loading

In high-aspect-ratio structures, small features etch slower by nature. CW, even with lower pressure and higher bias, helps little; PW periodically resets the surface state and can greatly narrow the gap, letting deep and shallow features advance together — critical for 3D NAND and advanced logic.

What the supply must do

Etch chambers are timing-sensitive, so the supply needs fast switching, accurate repetition rate and duty-cycle control, plus synchronization with the chamber. Prefer wide-range, clean-waveform pulse power supplies and verify against your chamber; see the pulse power category for the full range.

Related Articles

All News

Frequently Asked Questions

CW vs PW?
Under CW the supply delivers power continuously; the plasma never rests. Pulse mode chops the output into on-off cycles — full power for part of the period, off for the rest. That intermittent energy
Three practical benefits?
Interrupted heating: etching is exothermic; the off-time lets heat dissipate, avoiding local overheating and profile distortion. Reactant transport: during the gap, products and active species re-diff
Beating micro-loading?
In high-aspect-ratio structures, small features etch slower by nature. CW, even with lower pressure and higher bias, helps little; PW periodically resets the surface state and can greatly narrow the g
What the supply must do?
Etch chambers are timing-sensitive, so the supply needs fast switching, accurate repetition rate and duty-cycle control, plus synchronization with the chamber. Prefer wide-range, clean-waveform pulse