Selecting Pulse Power Supplies for Titanium Alloy Oxidation

2026-07-09
Selecting Pulse Power Supplies for Titanium Alloy Oxidation - Nenghua Power
Photo: Jinan Nenghua real products

Anodizing thickens the natural oxide film on aluminium and its alloys by making the workpiece the anode in an electrolytic cell. The power supply sets the current density and voltage profile, and therefore the structure, hardness and colour of the film.

For selecting Pulse Power Supplies for Titanium Alloy Oxidation, matching the supply to the real process counts for more than chasing the highest number on the datasheet.

Process basics

In the cell the aluminium workpiece is the anode; oxygen ions from the electrolyte migrate into the surface while aluminium ions move outward, building an oxide layer that is partly porous and partly dense barrier film.

Power supply requirements

The supply must deliver constant current with low ripple and hold it as the cell resistance rises with film thickness. Voltage compliance of 60 to 120 V covers most work, with hard anodizing often needing higher values late in the cycle.

Cooling and bath control

Anodizing generates heat in proportion to current, so bath temperature is controlled by chilled water or refrigerant. Hard anodizing normally runs near 0 C, which keeps the oxide dense and allows higher current density.

Quality and troubleshooting

Typical defects - soft coatings, burning, uneven colour - usually trace back to current density, bath temperature or contact resistance at the rack. Checking the actual current at the workpiece rather than the set-point resolves most cases quickly.

About the supplier

Jinan Nenghua Electromechanical designs and builds industrial DC power supplies, pulse power supplies and electrochemical power supplies for plating, anodizing, electrolysis and hydrogen production lines. Each unit is configured to the required voltage, current, ripple and cooling method, and is backed by commissioning and maintenance support.

Related Articles

All News

Frequently Asked Questions

Process basics?
In the cell the aluminium workpiece is the anode; oxygen ions from the electrolyte migrate into the surface while aluminium ions move outward, building an oxide layer that is partly porous and partly
Power supply requirements?
The supply must deliver constant current with low ripple and hold it as the cell resistance rises with film thickness. Voltage compliance of 60 to 120 V covers most work, with hard anodizing often nee
Cooling and bath control?
Anodizing generates heat in proportion to current, so bath temperature is controlled by chilled water or refrigerant. Hard anodizing normally runs near 0 C, which keeps the oxide dense and allows high
Quality and troubleshooting?
Typical defects - soft coatings, burning, uneven colour - usually trace back to current density, bath temperature or contact resistance at the rack. Checking the actual current at the workpiece rather
About the supplier?
Jinan Nenghua Electromechanical designs and builds industrial DC power supplies, pulse power supplies and electrochemical power supplies for plating, anodizing, electrolysis and hydrogen production li