
The most common inverter selection mistake is buying to the load's rated power and then finding it cannot start. The reason is that many loads draw a starting surge far above their rating. A few key points are enough to get capacity and type right.
| Load type | Starting behaviour | Sizing rule |
|---|---|---|
| Incandescent lamps, heaters | No surge | Use rated power |
| Motors, pumps, compressors | Starting current several times rated | Use surge power with margin |
| Switch-mode equipment | Large inrush at power-on | Account for the transient |
| Several devices combined | Probability of simultaneous start | Calculate the worst case |
The inverter must match the DC side: common levels are 12 V, 24 V, 48 V and higher system voltages. Higher voltage means lower current for the same power and less line loss, so match the battery bank or DC bus voltage.
Size for the worst starting condition, not for the load's nameplate power. See inverters and locomotive inverters; the full range is in the inverter category.
Inverters are used widely, but requirements differ greatly …
2026-10-29Inverters are classified by output waveform mainly into pur…
2026-10-29When an inverter gives no output or alarms, the cause may l…
2026-10-29"High-frequency" and "line-frequency" are the most common w…
2026-10-29In the power equipment world the word "variable frequency" …
2026-10-29An inverter's task sounds simple: turn DC into AC. Building…